BearingNews
The Specialist for High & Super Precision Bearings
For more than six decades, CSC Bearing has been a manufacturer of rolling bearings, deep groove ball bearings and high precision bearings with currently...
Is all bearing surface damage troublesome? Combatting Corrosion at the Design...
Up to 40 per cent of a vegetable crop can go to waste due to the aesthetic requirements of some supermarkets. While a wonky...
‘Fit and Forget’ Actuators Provide a Low Maintenance Solution in a...
In recent months, due to the coronavirus pandemic, there has been a spike in demand for bread far in excess than previously seen. Whereas...
Linear Guides: Fretting
Damage Condition
Fretting is a type of wear that is caused by relative repeated rubbing with minute amplitude between contacting surfaces. It is called fretting...
Key Bearing Selection Factors For Medical Equipment
Bearings play a key role in a wide variety of medical equipment. From X-ray machines and oxygen compressors to small, handheld surgical instruments, it’s...
3rd International Expert Forum for Bearings – Rolling and Plain Bearings!
Get your free ticket now!
19 – 23 October, 2020
Virtual Presentations & Exhibition
The expert forum on bearings will be held as a free online event...
COC aims to replace all SN5 plummer block units in the...
One of COC's goals is to replace all SN5 plummer block units in the world with COC SN units.
Only a few manufacturers in the...
High cost savings through online condition monitoring and automatic lubrication of...
Installing condition monitoring devices on flood pumps and motors can provide advanced warning of any impending bearing failures
By installing vibration monitoring and...
ACORN appoints New Bearing and Maintenance Product Manager
Acorn Industrial Services Ltd is delighted to announce the appointment of its new Bearing and Maintenance Product Manager, Andy Fletcher. Andy brings with him...
Linear Guides: Wear
Damage Condition
Severe friction resulted in serious wear on the rolling contact surface of raceway and/or balls.
Possible Causes
Insufficient lubrication
Intrusion of foreign matter
Improper...
